A small footprint guitar interface that cuts out the hum but keeps the parts that are hummable.

The engineering brains at Waves and Paul Reed Smith guitars have put their heads together to create this high-quality interface which transforms your unbalanced high impedance guitar signal into a balanced low impedance signal, reducing hum and retaining your full dynamic range. The result is ultra-high fidelity at the most critical point in the signal path. The compact black box features studio-grade jacks, a large Gain knob, LED indicators for level, low battery, and power. It's transparent pre-amp and custom-designed circuitry are just what you need when you're ready to lay down your hot new guitar licks.

Waves PRS Guitar Interface Features:

• Transparent pre-amplifier
• Custom-designed circuitry
• Audiophile-quality components
• Studio-grade balanced and unbalanced jacks (one XLR and 1/4" TS jack each)
• Micorophone/line level outputs
• Gain knob
• LED lights to indicate signal present, nominal level, and over

Capture your guitar's full dynamics and fidelity, and leave the buzzing for something else. Order this potent interface today!

Waves PRS Guitar Interface Specifications:

• Dimensions: 9.5cm (W) x 4.3cm (H) x 11.5cm (D)
• Weight: 356g
  
  TRS input
• Input impedance: >1 Mega Ohm unbalanced
• Max input level: 1.1 VRMS.
• Power saving switch: Automatic shut down when input jack is not connected
  
  Balanced XLR input
• All measurements were performed with volume at a nominal setting
• Output impedance: 50 ohm
• S/N: >105 at line level, (S measured at 1%, 1kHz, A-weighted)
• Response: 20-20kHz, -3dB @ 11kHz, -5dB at 20kHz
• THD+N: <0.005 (< -90dB) at -10dB below max sensitivity level
• Sensitivity: 1.1Vrms at line level, 2.5 Vrms at mic Level
• Gain: 11dB at line level, -28dB at mic level. ±1.5dB
• Volume range: +5dB, -10dB refer to nominal setting
• Output short circuit protection: Ground lift switch
• Power: Two 9V Batteries, 12-18V DC, 0.5A minimum
  
  Unbalanced PL Jack output
• All measurements were performed with volume at a nominal TD setting
• Output impedance: 50 ohms
• Output impedance: 100 ohms
• S/N: >105 at line level, (S measured at 1%, 1kHz, A-weighted)
• Response: 20-20Khz, -3dB at 11kHz, -5dB at 20kHz
• THD+N: <0.005 (< -90dB) at -10dB below max sensitivity level